Completed BSc diplomas topics
| 1. | Analysis of polymer composites using injection moulding and extrusion based additive manufacturing technologies |
| Pasics Ádám - 2023 |
| 2. | Material substitutability test of a control unit cover made of polybutylene terephthalate |
| Stieber Balázs - 2023 |
| 3. | Effect of glass fiber breakage on the properties of recycled PA6 |
| Csapó Maja - 2022 |
| 4. | Investigation of product color homogeneity produced with hot runner system |
| Ujj Bence Tibor - 2021 |
| 5. | Influence of technological parameters on the efficiency of meltflippers used in large cavity injection molds |
| Pál Kristóf - 2020 |
| 6. | Effect of gate position on filling the cavity in a hot runner mold |
| Varga Ákos - 2020 |
| 7. | Investigation of material change in hot runner molds |
| Vincze Balázs - 2020 |
| 8. | Sensoring in injection molding |
| Pázmány Miklós - 2019 |
| 9. | Examination of products 3D printed with by SLS |
| Bui Quang Anh - 2019 |
| 10. | Investigation of purge compaunds effectiveness in injection molded bumpers |
| Rakusz Máté - 2019 |
| 11. | Investigation of the effect of adaptive process control on the properties of injection molded automotive parts |
| Bihari Zsófia - 2019 |
| 12. | Characterication of surface properties of polyamide 6 samples prepared through in-situ polymerization |
| Puskás Arnold - 2018 |
| 13. | The effect of masterbatch on the shrinkage of injection molded products |
| Békefi Balázs Tamás - 2018 |
| 14. | Effect of injection molding screw tips on fiber breakage in the case of injection molded short fiber composites |
| Pocsai Lilla - 2018 |
| 15. | Lifetime analysis of rapid molds used in injection molding |
| Zorics Richárd - 2018 |
| 16. | Investigation of the effect of processing techonlogies in injection moulded biopolymers |
| Németh Levente - 2017 |
| 17. | Evaluation of purging in injection molding |
| Tóth Csongor - 2017 |
| 18. | The development of non-contact measurement method for shrinkage |
| Szabó Ádám Kristóf - 2017 |
| 19. | The effects of injection molding parameters on the creep properties of the molded parts with weld lines |
| Ádám Csilla - 2016 |
| 20. | Evaluation of runner system with melt-flipper application in injection molds |
| Szabó Eszter - 2016 |
| 21. | In-situ dispersion of nano fillers in injection molding |
| Takács Bence - 2016 |
| 22. | Replacement possibilities of the beeswax-based comb and application of beekeeping |
| Ispán Róbert - 2016 |
| 23. | Investigation of mechanical properties of fused deposition molded parts with designed backfill |
| Perger Dávid - 2016 |
| 24. | The injection molding process capability and product quality characterisation at Anton Kft. |
| Varga János - 2016 |
© 2014 BME Department of Polymer Engineering - Created by: Dr. Romhány Gábor