Completed MSc diplom topics
| 1. | Development of an algorithm based on digital image analysis for automated screening of scrap products |
| Pécsi Lilla - 2025 |
| 2. | Investigation of the diameter unevenness on the part quality in the case of FDM technology |
| Bense Hajnalka Klára - 2024 |
| 3. | Analysis of melt homogeneity problems in multi-cavity molds |
| Gál Vilmos Csaba - 2022 |
| 4. | Filament production for FDM technology |
| Lengyel Zoltán - 2022 |
| 5. | Redesign of an electronic parking brake system and creation of a functional model using additive manufacturing technology |
| Nyeste Dániel - 2022 |
| 6. | Evaluation of mold filling imbalances with image processing |
| Rakusz Máté - 2021 |
| 7. | Investigation of filling phase imbalances in hot runner mold due to the nozzle location |
| Vas Richárd Lajos - 2021 |
| 8. | Investigation of injection molding parameters on the shrinkage with cavity pressure sensors |
| Pázmány Miklós - 2021 |
| 9. | Modeling the effect of melt flipper in multi cavity injection molds |
| Nyári Szilvia - 2021 |
| 10. | Holding phase optimization in injection molding based on cavity pressure curves |
| Párizs Richárd Dominik - 2020 |
| 11. | Analysis and modelling of the creep relaxation process of polymer composite parts produced injection molding |
| Simon Eszter - 2020 |
| 12. | Investigation the effects of melt flippers in multi-cavity injection mold |
| Pocsai Lilla - 2020 |
| 13. | Fröccsöntött termékek gyártására szolgáló kis-szériás szerszámok vizsgálata |
| Zorics Richárd - 2020 |
| 14. | Developing a new viscosity description method for injection molding simulation algorithms |
| Bartalos Balázs Tibor - 2019 |
| 15. | Analysis of the creep and stress relaxation process of the parts produced by additive manufacturing |
| Kőszegi Réka - 2019 |
| 16. | Testing of screw tips for injection molding defect modification |
| Horváth Kristóf - 2017 |
| 17. | Development of a measurement system for evaluation of surface defects of injection molded products |
| Rácz Róbert - 2017 |
| 18. | Evaluation of fiber breakage in injection molding |
| Szendrei László - 2017 |
| 19. | Comparative testing of extrusion blow molds manufactured with different additive technologies |
| Hizsnyai Máté - 2017 |
| 20. | Parameter optimization of camera system for quality control of assembled injection moulded parts |
| Vincze Ákos - 2017 |
| 21. | Development of special screw tip for injection molding |
| Pawletko Peter Harald - 2016 |
| 22. | Fröccsöntő csigacsúcsok gyakorlati fejlesztése és tesztelése |
| Kósa Endre - 2015 |
| 23. | Technológia- és szerszámfejlesztés fröccsöntés közbeni összecsapási hiba kiküszöbölésére |
| Bille Péter - 2015 |
| 24. | Keverő rendszerek fejlesztése és tesztelése fröccsöntéshez |
| Szép Gergely - 2015 |
© 2014 BME Department of Polymer Engineering - Created by: Dr. Romhány Gábor